Rockers & Rollers


These funky rocker boxes were slightly warped (especially on the little center boss) from most likely a variety of causes, ie; heat, sanding, polishing, etc.  You want them flat against the gasket surface so you aren't binding or pulling when torquing the rocker bolts.  After fly cutting, a fine burr was removed.

These Strociek rocker arms were touching the upper collars slightly on the exhaust.  I first checked without the gaskets . . . we'll be ok with that extra gasket height.  Assemble, check, disassemble, clearance, reassemble, check, disassemble, clearance, reassemble, check, disassemble . . . etc etc . . . . I'm buying common stock in the Sharpie Marker Company (which I use instead of bluing)


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.