Morty says . . .


. . .  that solvent and glyptal stinks.  I got this 4 speed all solvent washed, blow dried, bead blasted, blown off, solvent washed again, blow dried, washed in hot soapy water, rinsed in hot clean water, blow dried and a bit of WD-40 on the race.  Then I cut down a thread insert, fitted and loc-tite'd in the case.  Loc-Tite in stud.  Glyptal case to seal.  Then heat to 250 degrees for a bit to cure.  Then carry-on brothers . . .

3 comments:

Cycle Nazi said...

ive seen that trans some wheres else...aint I

Kris Klein said...

Lookin good Noot.

Anchor Motorsickle said...

Oh that is all there is to getting that oh so clean look.