Stroker Power Reinforcement

Chris' stroker has had some damage over the years, but the "fix" and reinforcement of the countershaft area was well done.
Below:  The "Corner" (as we like to call it) has been strengthened and built-up with a solid boss. 
The only thing I might do . . . is remove the needle bearing and make a little oil slot on the top, outside to help oil the bearing (like the factory did). 
Then I could check the bearing needles, press fit, etc. too . . .

1 comment:

Mct496 said...

That's a good idea when I doubt do it like the factory did