Left Side Timken Spacer

If you get your left side case all assembled (bearings pressed) and you find there's a little too much end play...... you can surface grind a small amount off your center spacer.  Some look like this (others are completely round with "timken" stamped on them).  If it's too tight (you need a thicker spacer, because the bearings are smashed against the races).  That's why the instructions are so strict on using the supplied spacer with your bearing kit, since all the tolerances are set up for that particular combination of bearings and races.  When you install your pulley (or compensating sprocket) it could take up a slight amount of end-play, so you need to take that into consideration too.  It's pure luck any of these garage builds work as good as they do with so much shit that could happen to just ruin your day !  Hey, why's my motor making these squealing sounds ???????

4 comments:

lucky23design said...

Which is exactly why we pay guys like you to do it for us!

WhitelinePsycho said...

Presactly Lucky23 . . . still, it's always amazed me how many of my mates will diy things like bottom ends several times with disastrous results then finally get it done correctly by someone who actually can.

Wes said...

I made a huge bolt that I can install in the left case with the bearing set and torque to the spec of the compensating sprocket nut. Then I check the end play with an indicator mounted to a steel plate that bolts onto the inner primary mounting location. I've never found one out of spec when purchased in a kit, but I always check em anyway.

tbody321 said...
This comment has been removed by the author.